02385nas a2200253   4500008004100000022001400041245008400055210006900139260007100208300001600279490000600295520147900301653002101780653002001801653002001821653001401841653003001855100002501885700002701910700002801937700002701965700002401992856011502016       2015                        eng d  a1944-824400aCarbon nanohorn-derived graphene nanotubes as a platinum-free fuel cell cathode0 aCarbon nanohornderived graphene nanotubes as a platinumfree fuel  a1155 16TH ST, NW, WASHINGTON, DC 20036 USAbAMER CHEMICAL SOCcNOV  a24256-242640 v73 a<p>Current low-temperature fuel cell research mainly focuses on the development of efficient nonprecious electrocatalysts for the reduction of dioxygen molecule due to the reasons like exorbitant cost and scarcity of the current state-of-the-art Pt-based catalysts. As a potential alternative to such costly electrocatalysts, we report here the preparation of an efficient graphene nanotube based oxygen reduction electrocatalyst which has been derived from single walled nanohorns, comprising a thin layer of graphene nanotubes and encapsulated iron oxide nanopartides (FeGNT). FeGNT shows a surface area of 750 m(2)/g, which is the highest ever reported among the metal encapsulated nanotubes. Moreover, the graphene protected iron oxide nanoparticles assist the system to attain efficient distribution of Fe-N-x and quaternary nitrogen based active reaction centers, which provides better activity and stability toward the oxygen reduction reaction (ORR) in acidic as well as alkaline conditions. Single cell performance of a proton exchange membrane fuel cell by using FeGNT as the cathode catalyst delivered a maximum power density of 200 mW cm(-2) with Nafion as the proton exchange membrane at 60 degrees C. The facile synthesis strategy with iron oxide encapsulated graphitic carbon morphology opens up a new horizon of hope toward developing Pt-free fuel cells and metal-air batteries along with its applicability in other energy conversion and storage devices.</p>10acarbon nanohorns10acarbon nanotube10aelectrocatalyst10afuel cell10aoxygen reduction reaction1 aUnni, SreeKuttan, M.1 aIllathvalappil, Rajith1 aBhange, Siddheshwar, N.1 aPuthenpediakkal, Hasna1 aKurungot, Sreekumar  uhttp://library.ncl.res.in/content/carbon-nanohorn-derived-graphene-nanotubes-platinum-free-fuel-cell-cathode-002871nas a2200253   4500008004100000022001400041245010000055210006900155260000800224300001400232490000600246520202700252653002002279653002002299653001402319653003002333653001602363100002802379700001502407700001902422700002302441700002402464856012902488       2020                        eng d  a2574-097000aFeNx/FeSx-anchored carbon sheet-carbon nanotube composite electrocatalysts for oxygen reduction0 aFeNxFeSxanchored carbon sheetcarbon nanotube composite electroca  cMAR  a2234-22450 v33 a<p>Even though various Pt-free electrocatalysts for oxygen reduction reaction (ORR) have been introduced, many of them are found to be active only in alkaline conditions. Considering Nafion, phosphoric acid-doped polybenzimidazole (PBI), and so on as the prominent ionomer membranes, used in the commercially available polymer electrolyte membrane fuel cells (PEMFCs), it becomes important that any development on the Pt-free catalysts should ensure the better ORR performance under acidic conditions. The present work effectively tackles this issue, where an ORR-based catalyst could be prepared with simultaneous incorporation of both Fe-N and Fe-S active sites on in situ generated carbon sheets which are spatially separated by the carbon nanotube (CNT) network. This catalyst shows ability to perform under both acidic and basic conditions. This has been achieved by growing a polyethylenedioxythiophene polymer network in the presence of CNT and melamine followed by its pyrolysis under an inert atmosphere. The catalyst formed at 900 degrees C (PMCNT-900) displays 0.94 V onset potential for ORR under acidic electrolyte conditions, which corresponds to 60 mV overpotential compared to its 40 wt % Pt/C counterpart. Interestingly, in single cell demonstration of Nafion-based PEMFC with PMCNT-900 as the cathode catalyst, the system delivered a maximum power density (PD) of 500 and 275 mW/cm(2) at 60 degrees C under H-2-O-2 and H-2-air feed conditions, respectively. On the other hand, in a single cell test in the anion exchange membrane fuel cell (AEMFC) mode, a maximum power density of 65 mW/cm(2) at 50 degrees C could be achieved with the same cathode catalyst, which is a comparable value obtained while employing Pt/C as the cathode. These results, thus, infer to the efficiency of the catalyst to facilitate ORR under the extreme pH conditions, and particularly its performance under acidic condition reveals its prospect as a potential Pt-free electrocatalyst to serve in the Nafion-based systems.</p>
10acarbon nanotube10aelectrocatalyst10afuel cell10aoxygen reduction reaction10aPt-free ORR1 aBhange, Siddheshwar, N.1 aSoni, Roby1 aSingla, Gourav1 aAjithkumar, T., G.1 aKurungot, Sreekumar  uhttp://library.ncl.res.in/content/fenxfesx-anchored-carbon-sheet-carbon-nanotube-composite-electrocatalysts-oxygen-reduction